building decking on uneven ground

Set the four corners for the deck. Digging about 6 inches into the ground, create holes for the blocks so you can adjust (raise or lower) to make them even. The blocks should be spaced to make a 7' x 19' rectangle, leaving about 6 inches from each block for deck boards to add another 8' x 20' rectangle. Using a string level 

The best way to solve this problem is to use a level across each tread that you cut. This helps to keep the stringers aligned, which add stability to the steps you're building. Falling down steps can be dangerous, and therefore, safety is a top priority, especially when it comes to building deck stairs on uneven ground.

For all your trade and DIY tools and materials visit www.tradessupermarket.com For DIY videos, expert advice and a great shop all in one visit htt

Step by step DIY guide to how to lay timber decking. Update your garden space with an attractive and practical raised deck in 11 easy to follow steps.

Other options for this foundation part of the job include concreting pressure treated wooden posts in the ground at regular intervals to support the frame this is particularly useful for creating a level deck on a sloping site. Dedicated deck blocks that are slotted to take the joists of the frame are also available.

Building a raised garden bed over sloping ground is simple if you build it 'in place'. Here's the Building the raised beds over uneven, sloping ground was another matter. We wanted For fastenings, I used 4” decking screws throughout the project, and pre drilled the screw holes with a 1/8” bit. If you use 

Remove turf inside the area and 5cm of topsoil. Level the ground if slightly uneven, remembering to allow for the slope of 1:80. Make sure the ground is firm. 2. Place paving slabs at each corner and midway along where each bearer will be, including the edges, or every 1.5m if you are laying a larger deck. 3. Mark the area 

have a sturdy foundation for garden decking, but concrete, unlike soil, cannot easily be adjusted to create a level surface. Constructing the deck's frame first and then using the frame as a guide is the simplest way to lay garden decking on uneven concrete. For both ground level and raised garden decks, 

On uneven ground, find the number of treads so you can find the exact stair landing point. Simply subtract 1 from the number of risers. (There's always one fewer tread than risers, as you can see in Fig. B.) Then, multiply by 10.25 in., the ideal tread width for two 2x6s, to get the total run. Measure out that distance from the