retaining wall supporting a surcharge definition

Retaining walls. Building work in connection with a retaining wall that: Iai retains not more than 1.5 metres depth of ground, ' and. (b) does not support any surcharge orenyload additional to the load of that ground (for example, the load of vehicles),. This exemption allows You to build a retaining wall Iwhich is any wall 

However, these sections of the code do not address the following three items: 1. Design fluid pressures for retaining walls supporting retained soil that is other than level backfill. 2. Methods of determining surcharge loads on walls. 3. Criteria for accepted engineering practice for design of retaining walls.

requirements for when a building permit is required for the installation of a retaining wall. Retaining Walls & Definitions height measured from the bottom of the footing to the top of the wall, unless supporting a surcharge …” It is a common misconception by builders, designers, landscape contractors, pool contractors and.

Construction of retaining walls, except those less than 3 feet in height and not supporting surcharge, requires a permit and is regulated by the 2013 California Building Code (CBC) as amended and adopted by the County of San Diego. This form outlines the County's minimum requirements. The companion form PDS #084 

Definitions: Cantilever Retaining Wall The most common cantilever wall types are reinforced masonry or concrete retaining walls. These walls typically use steel reinforced masonry units or formed concrete from the bottom of footing to the top of the wall, unless supporting a surcharge (or impounding Class I, II, or IIIA 

by a licensed architect or engineer. ▫. Retaining Walls that: a) Measure more than 4 feet from the bottom of the footing to the top of the retaining wall; and/or b) Support a surcharge or impound Class I, II, or III A liquids. ▫. See Page 2 for General Definitions. COUNTY OF LAKE. COMMUNITY DEVELOPMENT DEPARTMENT.

Surcharge: The vertical load imposed on retained soil that may impose a lateral force in addition to lateral earth pressure of retained soil. For example: Sloping retained soil; structure footings supported by the retained soil; adjacent vehicle loads supported by retained soil. Retaining Wall Height: The vertical 

However, the term is usually used with reference to a cantilever retaining wall, which is a freestanding wall without lateral support at its top. For instances, additional surcharges may need to be considered and allowance made for any possible future removal of ground in front of the wall in connection with 

We include definitions of important retaining wall terms such as wall surcharge, and we provide diagnostic descriptions & photographs of types of damage to from Folsom CA building department drawings, illustrate the differences in how a segmental gravity retaining wall and a cantilevered retaining wall are supported.

g:\devadm\toby\retaining wall\retaining wall guideline.docx. Retaining Wall Guideline defined as being below a 1H:1V plane extending downwards from the outside of a building footing. 2.2. Types of Retaining .. Walls should be designed to support the appropriate full lateral earth, surcharge, and water pressures as.

Submit Construction Certificate, Bridge. Maintenance Manual and 'As Built'. Drawings. Does the structure support the highway? Is the structure a retaining wall Design Standards for Culverts and Simple Bridges submitted to the. County Council for Approval and/or Adoption. 1. Definitions. For the purposes of this note:.

lateral loads and do not account for any surcharge and seismic lateral earth pressures other than the slope as shown. The design professional is responsible for complete analysis in accordance with Section 1807 for retaining walls and site walls supporting a maximum of 6 ft high backfill as measured from 

The Covington Municipal Code adopts, by reference, IBC §105.2, item 5 and IRC §105.2, item 3, which state: “A building permit shall not be required for … retaining walls that are not over four feet in height measured from the bottom of the footing to the top of the wall, unless supporting a surcharge …” It is common 

Schedule 1: Exemption 20. A building consent is not required for the construction or alteration of any retaining wall that retains not more than 1.5 metres depth of ground and does not support any surcharge or any load additional to the load of that ground (for example, the load of vehicles on a road). Retaining wall urban.

Under certain conditions, the block weight and setback alone do not provide enough structural support. This is where geogrid comes in Allan Block's Reinforcement Grid™ provides a simple solution by creating a solid structure with more resistance to soil pressure and surcharges for retaining walls under 6 ft. (1.8 m) tall.

Looking for surcharge? Find out information about surcharge. 1. a charge in addition to the usual payment, tax, etc. 2. an excessive sum charged, esp when unlawful 3. Law the act or an instance of surcharging 4. Explanation of surcharge.